I watched a YouTube video that some guy used an identical setup like mine and the Ethernet cable was a rollover cable.Well Ive tried replacing the Ethernet segment as straight through and rollover but still no luck.
Im using putty and the Default settings as VT100 for keyboard and a baud rate of 9600 with acceleration off. It would be super helpful if anyone could point me in the right direction with this project. If you are sure the adapters you are using are the same pin out, then you just need an RJ45 cable that will swap TX and RX pins. You could use a volt meter with continuity check to figure out what db9 pin matches to what rj45 pin. Or trade your rj45 converters for a standard null modem cable. I dont think the powerconnect needs flow control, so if you can get tx, rx and gnd you should be good. Are you sure you had the pin out on the rollover cable correct. Well show you exactly what to enable in the web interface as well as the equivalent command line terminal commands. Click the Gear icon on the right of the Edit Global Parameters window. If you click back on the Gear icon, youll notice the Local Engine ID field is now configured with the default Engine ID and the Local Engine ID Type is set to User-Defined. On the Add Access Control window, set the following options. Dell Powerconnect 6248 Default Free Paessler SNMPIf you would like to test it, you can verify everything is working properly the free Paessler SNMP Tester tool. Match the settings as seen below and set it to check the Uptime. If successful, youll see the uptime returned to you in the results. Web page addresses and e-mail addresses turn into links automatically.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |